Knog Pwr Trail 1100 USB Rechargeable Front Light

PWR Trail is a modular bike light. But it's not JUST another bike light. Not only is it a high powered bike light, but simply take the product apart and you have much more. A lighthead and a PWR Bank to charge devices that is also the battery for all products in the PWR range.

 

BATTERY INDICATOR - Hate it when you run out of battery with no warning? That'll never happen with PWR Trail, with 4 built in battery indicator lights. Tap the bottom of the light to activate the battery indicator. 4 lights = fully charged, 2 lights = half charged etc.

EASY TO MOUNT & USE - This light can be mounted on top or below your handlebars, directly under your Garmin, or on your helmet. It comes with a side mount and shim that fits handlebars 22.2-38.1mm diameter. Once mounted, using PWR Trail is a breeze. It's a simple twist-head operation to turn light on & off and to scroll through light modes.

CHARGE YOUR DEVICES - Press the red button to release the lighthead, and use the PWR bank to charge your phone, GoPro, cycle computer or other device. 1 hour riding @1000 lumens means you can top up charge your iPhone by 75%. Charge your PWR Trail using the included micro USB cable, charge time is 3.5 hours.

WIDE BEAM & CUSTOMISABLE MODES - PWR Trail outputs a max 1100 lumens, and can run for up to 300 hours on Eco Flash Mode. Its elliptical beam gives broader, bright road coverage. It comes with 6 pre-programmed modes, and you can program the light to suit your needs with Modemaker. You can control brightness, adjust runtimes and add new light modes.

 

RUNTIME

MODE	LUMENS	RUNTIME
Max	1100	1.7hrs
Mid	600	2.5hrs
Stamina	90	18hrs
Pulse	330	7hrs
Strobe Flash	250	12hrs
Eco-Flash	17	250hrs

 

SPECIFICATION

• Dimensions - H: 128mm x W: 35mm x L:35mm.
• Weight - 230 grams.
• Lumens - 1100.

 

INSTRUCTIONS

Connect lighthead to PWR bank: Insert the two lighthead plug pins into the battery. When connected, your lightheads LED's will flash.

Connect lighthead to sidemount: Slide the mount into the slot on the side of the battery. Then tighten the thumbwheel. To remove the mount you will need to loosen the thumbwheel.

Operation: Once the lighthead and battery are connected, twist the lighthead and hold to turn on, twist and release to change modes.

Occasionally, without notice, manufacturers change product design and/or specifications.